Home › Products › Telemetry & Networking › SCADA Transmitter
Telemetry
ALERT2 SCADA Two-Way Transmitter
Everything the 50386 data transmitter does — generous sensor capacity, local logging, event and timed reporting — plus a return path. From the office you can poll the station on demand, change its configuration remotely, and operate control outputs: gates, pumps, valves, warning signs. Commands over the return path are protected by the ALERT2 protocol's encryption and authentication — how two-way networks stay secure →
Configure this in the Selector → Download 50388/A2 datasheet (PDF)
Capabilities and options
Built in
- 16 analog inputs
- 12 digital inputs
- 1 SDI-12 port
- 2 RS-232 serial ports
- Local data logging
- Event + timed reporting
- Two-way: remote polling, remote configuration, supervisory control outputs
- ALERT2 encoder + GPS receiver (on /A2)
Factory options
- Digital status connector, 10-pin MS OP2
- 6-serial-port expansion OP4
- Internal power supply OP6
- ScadaLynx radio OP8
- Network interface OP14
- Cellular radio modem OP21
- Iridium satellite modem OP22
- Wi-Fi radio modem OP23
Specify at order
- Radio model and power specify
- Licensed operating frequency specify
Only need one-way reporting? The 50386/A2 data transmitter is the simpler, proven choice.
Where it's used
The 50388 is the platform inside every 58xx packaged station — rain 5854, level 5890, weather 5881 and water quality 5891 — and it's available alone for custom SCADA installations: gate and pump control, reservoir operations, and any site where the office needs to act, not just observe.